Door Control Transmitter (W/O Smart Key System)

REMOVAL




1. REMOVE TRANSMITTER BATTERY
a. Remove the transmitter battery.
1. Using a screwdriver with its tip wrapped in protective tape, pry open the transmitter housing cover.

NOTE: Do not use excessive force when prying open the housing cover.




b. Remove the door control transmitter module from the transmitter housing case.




c. Using a coin, or other flat object, pry open the transmitter cover.




d. Remove the transmitter battery (lithium battery).

NOTE:
- Do not push the terminals with your finger.
- Do not forcibly pry up the battery (lithium battery) because doing so will deform the terminals.
- Do not touch the battery with wet hands. Water may result in corrosion.
- Do not touch or move any components inside the transmitter because handling the components may interfere with proper operation of the transmitter.

INSTALLATION




1. INSTALL TRANSMITTER BATTERY
a. Install the transmitter battery.
1. Install a battery (lithium battery: CR2016) with the positive (+) side up, as shown in the illustration.

NOTE:
- Be sure that the positive and negative sides of the transmitter battery are positioned correctly.
- Be careful not to bend the terminals of the transmitter battery during installation.
- Keep the interior of the transmitter case free of dust, water, and oil.




b. Install the door control transmitter module into the transmitter housing case.




c. Install the transmitter housing cover securely onto the transmitter housing case.

HINT: After the installation, press one of the transmitter switches and check that the LED illuminates.