Engine Control Module: Service and Repair
REMOVAL1. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH
2. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH
3. REMOVE FRONT FENDER TO COWL SIDE SEAL LH
4. REMOVE FRONT FENDER TO COWL SIDE SEAL RH
5. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
6. REMOVE WINDSHIELD WIPER MOTOR AND LINK
7. REMOVE COWL TOP OUTER PANEL SUB-ASSEMBLY
8. REMOVE ECM
a. Remove the 3 nuts.
b. Disconnect the 2 ECM connectors and remove the ECM.
1. Raise the 2 levers while pushing the locks on the 2 levers, and disconnect the 2 ECM connectors.
NOTE: After disconnecting the connector, make sure that dirt, water and other foreign matter do not contact the connecting part of the connector.
2. Remove the ECM.
c. Remove the 4 screws and 2 ECM brackets.
INSTALLATION
1. INSTALL ECM
a. Install the ECM bracket with the 4 screws.
Torque: 3.0 N.m (31 kgf.cm, 27 in.lbf)
b. Connect the 2 ECM connectors.
NOTE: When connecting the connector, make sure that dirt, water and other foreign matter do not become stuck between the connector and other parts.
1. Connect the 2 ECM connectors and lower the 2 levers.
NOTE: Make sure that the 2 levers are securely lowered.
c. Install the ECM with the 3 nuts.
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
2. INSTALL COWL TOP PANEL OUTER SUB-ASSEMBLY
3. INSTALL WINDSHIELD WIPER MOTOR AND LINK
4. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
5. INSTALL FRONT FENDER TO COWL SIDE SEAL RH
6. INSTALL FRONT FENDER TO COWL SIDE SEAL LH
7. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH
8. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL