Knock Sensor: Service and Repair
REMOVAL1. DISCHARGE FUEL SYSTEM PRESSURE
2. REMOVE ENGINE UNDER COVER LH
3. REMOVE ENGINE UNDER COVER RH
4. DRAIN ENGINE COOLANT
5. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH
6. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH
7. REMOVE FRONT FENDER TO COWL SIDE SEAL LH
8. REMOVE FRONT FENDER TO COWL SIDE SEAL RH
9. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
10. REMOVE WINDSHIELD WIPER MOTOR AND LINK
11. REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY
12. REMOVE COOL AIR INTAKE DUCT SEAL
13. REMOVE V-BANK COVER SUB-ASSEMBLY
14. REMOVE AIR CLEANER INLET ASSEMBLY
15. REMOVE AIR CLEANER CAP SUB-ASSEMBLY
16. REMOVE AIR CLEANER CASE SUB-ASSEMBLY
17. REMOVE NO. 1 AIR CLEANER INLET
18. REMOVE INTAKE AIR SURGE TANK
19. SEPARATE FUEL TUBE SUB-ASSEMBLY
20. REMOVE INTAKE MANIFOLD
21. REMOVE KNOCK CONTROL SENSOR
a. Disconnect the 2 knock control sensor connectors.
b. Remove the 2 bolts and 2 knock control sensors.
INSTALLATION
1. INSTALL KNOCK CONTROL SENSOR
a. Install the 2 knock control sensors with the 2 bolts as shown in the illustration.
Torque: 20 N.m (204 kgf.cm, 15 ft.lbf)
b. Connect the 2 knock control sensor connectors.
2. INSTALL INTAKE MANIFOLD
3. CONNECT FUEL TUBE SUB-ASSEMBLY
4. INSTALL INTAKE AIR SURGE TANK
5. INSTALL NO. 1 AIR CLEANER INLET
6. INSTALL AIR CLEANER CASE SUB-ASSEMBLY
7. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
8. INSTALL AIR CLEANER INLET ASSEMBLY
9. INSTALL V-BANK COVER SUB-ASSEMBLY
10. INSTALL COOL AIR INTAKE DUCT SEAL
11. INSTALL COWL TOP PANEL OUTER SUB-ASSEMBLY
12. INSTALL WINDSHIELD WIPER MOTOR AND LINK
13. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
14. INSTALL FRONT FENDER TO COWL SIDE SEAL RH
15. INSTALL FRONT FENDER TO COWL SIDE SEAL LH
16. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH
17. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH
18. ADD ENGINE COOLANT
19. CHECK FOR ENGINE COOLANT LEAKS
20. CHECK FOR FUEL LEAKS
21. INSTALL ENGINE UNDER COVER RH
22. INSTALL ENGINE UNDER COVER LH