ACC Signal Circuit

LIGHTING (INT): LIGHTING SYSTEM: ACC Signal Circuit

ACC Signal Circuit

DESCRIPTION

This circuit detects the ignition switch ACC or off condition, and sends it to the main body ECU (driver side junction block assembly).

WIRING DIAGRAM









INSPECTION PROCEDURE
NOTICE: Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. READ VALUE USING TECHSTREAM
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Data List.
(e) Read the display on the Techstream.

Main Body





OK:
Normal conditions listed above are displayed.

NG -- INSPECT ACC RELAY
OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
2. INSPECT ACC RELAY




(a) Remove the ACC relay from the main body ECU (driver side junction block assembly).
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:






NG -- REPLACE ACC RELAY
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY AND BODY GROUND)




(a) Disconnect the 2A main body ECU (driver side junction block assembly) connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:





Text in Illustration








(c) Disconnect the 2F main body ECU (driver side junction block assembly) connector.
(d) Measure the resistance according to the value(s) in the table below.
Standard Resistance:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

4. CHECK VEHICLE CONDITION
(a) Check the vehicle condition.
Result:





B -- CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - MAIN BODY ECU)
A -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - IGNITION SWITCH)




(a) Disconnect the D12 ignition switch connector.
(b) Disconnect the 2G main body ECU (driver side junction block assembly) connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

6. INSPECT IGNITION SWITCH




(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:





Text in Illustration





NG -- REPLACE IGNITION SWITCH
OK -- REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
7. CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - MAIN BODY ECU)




(a) Disconnect the 2G main body ECU (driver side junction block assembly) connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)