Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

Torque: 18 Nm (178 kgf-cm, 13ft-lbf)

NOTICE:
- If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
- When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
- When the ignition switch is first turned to on after the center airbag sensor assembly has been replaced, make sure that no one is in the vehicle.

(d) Connect the connector to the center airbag sensor assembly as shown in the illustration.
NOTICE: When connecting the airbag connector, take care not to damage the airbag wire harness.

(e) Check that the waterproof sheet is properly set.
(f) Check that there is no looseness in the installation parts of the center airbag sensor assembly.
2. INSTALL CONSOLE BOX SUB-ASSEMBLY Installation
3. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation
4. INSTALL CONSOLE BOX ASSEMBLY Installation
5. INSTALL NO. 2 CONSOLE BOX CARPET Installation
6. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation
7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH Installation
9. INSTALL FRONT DOOR SCUFF PLATE RH Installation
10. INSTALL AIR CONDITIONER CONTROL ASSEMBLY Installation
11. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System) Installation
12. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System) Installation
13. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Installation
14. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
15. INSTALL FRONT DOOR SCUFF PLATE LH Installation
16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

17. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check DTC Check / Clear.
18. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.