Height Control Sensor Circuit

LIGHTING (EXT): LIGHTING SYSTEM: Height Control Sensor Circuit
- Height Control Sensor Circuit

DESCRIPTION

The headlight leveling ECU assembly receives signals indicating the height of the vehicle from the rear height control sensor sub-assembly RH.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH

(a) for 2WD:

(1) Connect 3 dry cell batteries (1.5 V) in series.





(2) Remove the rear height control sensor sub-assembly RH.

(3) Connect a positive (+) lead from the batteries to terminal 3 (SHB) and a negative (-) lead from the batteries to terminal 1 (SHG).

(4) Measure the voltage between terminals 2 (SHRR) and 1 (SHG) while slowly moving the link up and down.

Standard Voltage:





Text in Illustration





(b) for AWD:

(1) Connect 3 dry cell batteries (1.5 V) in series.





(2) Remove the rear height control sensor sub-assembly RH.

(3) Connect a positive (+) lead from the batteries to terminal 3 (SHB) and a negative (-) lead from the batteries to terminal 1 (SHG).

(4) Measure the voltage between terminals 2 (SHRR) and 1 (SHG) while slowly moving the link up and down.

Standard Voltage:





Text in Illustration





NG -- REPLACE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH Components
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (ECU - REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH)

(a) Disconnect the A40 headlight leveling ECU assembly connector.





(b) Disconnect the N1 rear height control sensor sub-assembly RH connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Exterior Lighting System