Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: YAW RATE AND ACCELERATION SENSOR: INSTALLATION

1. INSTALL YAW RATE AND ACCELERATION SENSOR

(a) Install the yaw rate and acceleration sensor to the bracket with the 2 nuts.

Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)





(b) Install the yaw rate and acceleration sensor with bracket with the 2 bolts.

Torque : 13 Nm (127 kgf-cm, 9 ft-lbf)





NOTICE:
* Be sure to insert the yaw rate and acceleration sensor claw into the stopper hole while installing the yaw rate and acceleration sensor.
* Do not damage the yaw rate and acceleration sensor.
* Make sure that the yaw rate and acceleration sensor is installed securely.

(c) Connect the connector to the yaw rate and acceleration sensor.

NOTICE:
Make sure that the yaw rate and acceleration sensor connector is connected securely.

2. INSTALL NO. 4 CENTER MEMBER FLOOR REINFORCE SUB-ASSEMBLY

(a) Install the No. 4 center member floor reinforce sub-assembly with the 7 bolts.

Torque : 19 Nm (194 kgf-cm, 14 ft-lbf)





(b) Return the floor carpet assembly to an original state.

3. INSTALL CONSOLE BOX SUB-ASSEMBLY Installation

4. INSTALL POSITION INDICATOR HOUSING ASSEMBLY Installation

5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

6. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation

7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH Installation

9. INSTALL FRONT DOOR SCUFF PLATE RH Installation

10. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Installation

11. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation

12. INSTALL FRONT DOOR SCUFF PLATE LH Installation

13. INSTALL AIR CONDITIONING CONTROL ASSEMBLY Installation

14. INSTALL CONSOLE BOX ASSEMBLY Installation

15. INSTALL NO. 2 CONSOLE BOX CARPET Installation

16. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System) Installation

17. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System) Installation

18. INSTALL FRONT SEAT ASSEMBLY LH (for Manual Seat)

HINT
Refer to the instructions for Installation of the front seat assembly LH Installation.

19. INSTALL FRONT SEAT ASSEMBLY LH (for Power Seat)

HINT
Refer to the instructions for Installation of the front seat assembly LH Installation

20. INSTALL FRONT SEAT ASSEMBLY RH (for Manual Seat)

HINT
Perform the same procedure as the LH side.

21. INSTALL FRONT SEAT ASSEMBLY RH (for Power Seat)

HINT
Perform the same procedure as the LH side.

22. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

23. INSPECT SRS WARNING LIGHT

HINT
Diagnosis System.