DTC Memory, Mode 3

DTC Memory, Mode 3

- Press -3- button to select mode 3 DTC memory.

Display Will Appear As Shown

x Malfunction recognized
Module 10* --> MIL off Module 1A*

Module 10* or 1A* will be activated (alternately):
- Module 10 = Engine Control Module (ECM) -J220-
- Module 1A = Transmission Control Module (TCM) -J217-
- MIL OFF/ON = MIL switched OFF or ON
- Press -> button, any stored DTCs will be displayed in sequence.

Display Will Appear As Shown (example).

P0422

- Press -> button.

NOTES:
- If two or more DTCs are stored, the cause of the malfunction could be attributed to a second or following malfunction. Interpreting stored DTCs are found in the DTC table.
- After malfunctions have been repaired; clear DTC memory Mode 4 and create readiness code again.
- Press -C- button to exit mode 3.