Flywheel: Service and Repair
Sealing flange and flywheel/driveplate, removing and installing
1 - Seal
- Install with 10-203
- Lightly lubricate sealing lip
- To remove, remove sealing flange
2 - Woodruff key
- Check for tight fit
3 - 25 Nm (18ft lb)
4 - Mounting flange
5 - Gasket
- Always replace
6 - Crankcase
7 - 60 Nm (44ft lb) plus 1/4- turn (90 °)
- Always replace
8 - Washer
- Note installed position
9 - Pressure plate/driveplate
10 - Intermediate plate
- Must fit on guide sleeves
- Do not bend during assembly
11 - 10 Nm (7ft lb)
12 - Mounting flange with seal
- Replace only as unit
- Lightly lubricate sealing lip
13 - Seal
14 - Intermediate shaft
- First remove ignition distributor
- Axial clearance max. 0.25 mm (0.0098 in.)
15 - 0-ring
- Always replace
16 - Mounting flange, front