Sealing Flanges and Flywheel/Drive Plate

Sealing flanges and flywheel/drive plate, removing and installing

Note: Repair work on clutch; Refer to Transmission and Drivetrain, Manual Transmission Transaxle

1- 90 Nm 1/4 turn (90°) further
^ Replace
^ Threads and shoulder must be free of oil and grease
^ Use counter support tool 3415 to loosen and tighten
2- Crankshaft toothed belt sprocket
3- 15 Nm
4- Seal
5- Sealing flange
6- Cylinder block
7- 60 Nm 1/4 turn (90°) further
^ Replace
8- Flywheel/drive plate
9- Intermediate plate
^ Must be seated on dowel sleeves
^ Do not damage/bend when assembling
10- Sealing flange with oil seal
^ Only replace complete
^ Use protective sleeve supplied when installing
^ Remove oil pan to remove and install
^ Do not additionally oil or grease the oil seal sealing lip
^ Before installing, remove oil remains from crankshaft journal with a clean cloth.
^ Remove protective sleeve first after sealing flange has been slid onto crankshaft journal