With Manufacturer's Scan Tool

General notes on injection
^ The engine control module is equipped with On Board Diagnostic (OBD).Before performing repairs and troubleshooting the Diagnostic Trouble Code (DTC) memory of all control modules must be interrogated using the automatic test sequence (in Guided fault finding). This is necessary as the various control modules are interconnected via a data bus. Also the vacuum hoses and connections must be checked (unmetered air).
^ Fuel hoses in the engine compartment must only be secured with spring-type clips. The use of clamp or screw-type clips is not permitted.
^ The battery may only be disconnected when the ignition is switched off. If a coded radio is installed, obtain the radio code before disconnecting the battery.
^ For trouble-free operation of the electrical components, a voltage of at least 11.5 V is necessary.
^ Do not use sealing compounds containing silicone. Particles of silicone drawn into the engine will not be burned in the engine and cause damage to the oxygen sensors.
^ If the engine starts, runs for a short period and then stops, after troubleshooting, repairs or component tests, then the cause may be the immobilizer blocking the engine control module. In such cases the control module must be adapted.
^ During some checks it is possible that the control module will detect and store a fault. Therefore after completing all checks and repairs the DTC memory must be interrogated and if necessary erased.Interrogating and erasing DTC memory.
^ Models with an airbag are equipped with a crash fuel strut-off system. This system reduces the danger of a fire in a crash in that the fuel pump is switched off via the fuel pump relay.
^ When the door is opened the fuel pump is activated for 2 seconds to build up pressure in fuel system. This improves the starting characteristics of the engine.