Engine: Description and Operation

Sealing flanges and flywheel/drive plate, assembly overview





1- 90 Nm plus an additional 1/4 turn (90°)
^ Replace
^ Use counter-holder 3415 to loosen and tighten
^ Threads and shoulder must be free of oil and grease
2- Crankshaft toothed belt sprocket
3- 15 Nm
4- Seal
5- Sealing flange
^ Insert with silicone sealant D 176 404 A2
^ To remove and install, remove oil pan
6- Cylinder block
7- 60 Nm plus an additional 1/4 turn (90°)
^ Replace
8- Flywheel/drive plate
9- Intermediate plate
^ Must be located on alignment sleeves
10- Sealing flange with seal
^ Only replaced as complete unit
^ Support sleeve may only be removed after sealing flange has been slid onto crankshaft pin.