With Manufacturer's Scan Tool

Ignition System Components, Removing And Installing







1. Connector
- Black, 4 pin
2. Ignition coil with output stage -N70-, -N127-, -N291-, -N292-
- For removing use only removal tool T40039.
3. Circlip
- For Camshaft Position (CMP) sensor 2 -G163-
4. Spark plug, 30 Nm
- Remove and install with 3122B
- Type and electrode gap.
5. Connector
- Black, 3-pin
- Sensor and connector contacts are gold-plated
6. Bolt, 10 Nm
7. Camshaft Position (CMP) sensor -G40-*
8. Bolt, 25 Nm
9. Washer
- Conical
10. Hood
- For Camshaft Position (CMP) sensor 2 -G40-
- When installing note fixing arrangement
11. Bolt, 20 Nm
- Tightening torque influences the function of the knock sensor
12. Knock sensor (KS) 1 -G61-*
- Sensor and connector contacts are gold-plated
- Location: Cylinder block intake side
13. Knock sensor (KS) 2 -G66-*
- Sensor and connector contacts are gold-plated
- Location: Cylinder block intake side
14. Connector
- 2-pin
- Contacts gold plated
- Black for knock sensor (KS) 1 -G61-
- Black for knock sensor (KS) 2 -G66-
- Mark connector before removing
15. Ground wire
- Only loosen or tighten with ignition switched off
16. Bolt, 10 Nm
- Only loosen or tighten with ignition switched off