Horn: Service and Repair

Signal Horns

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1331)

• High Tone Horn (H2) and Low Tone Horn (H7) are activated in parallel by Vehicle Electrical System Control Module (J519).

• Removal and installation for High Tone Horn (H2) and Low Tone Horn (H7) is performed in the same way and is only described for one signal horn.

• The High Tone Horn (H7) / Low Tone Horn (H2) are installed on the left and right near the longitudinal members.

Removing

- Turn off the ignition and all electrical consumers.

- Remove front bumper cover.

- Disconnect electrical connection - 1 -.






- Remove the screw - arrow - and remove the horn - 2 - and its retaining plate.

Installing

Installation is performed in the reverse order of removal. Note the following:

• When installing the horn, make sure it is not touching any other components around it.

- Tighten the screws, retaining plate to longitudinal member, to 20 Nm.