Checking Pedal Sensor Is Working [EB10]

Checking Pedal Sensor Is Working
- Ignition off.





- Reinstall connector and control module.
- Disconnect test box.
- Ignition on.
- Erase DTCs.
- Exit DTM by switching ignition off.





NOTE: Before test driving, switch ignition off to exit DTM. If car's speed exceeds 10 km/h (6 mph) while diagnostic system is on, the control module will disconnect the ABS system.

- Test drive car as per FB. Test driving. Test Driving [FB]

If DTC does not reoccur:
- DTC was due to poor contact in control module connector. Follow procedure for loose contact as per HA5 and contact resistance and oxidation as per HA6. Checking Leads and Connections [HA]

If DTC reoccurs:
- Try another pedal sensor as per LF. Pedal sensor, replacement. Service and Repair