F10 Programming Transmitter Codes

Programming the transmitter key codes to the receiver module.


NOTE: The transmitter key codes are preprogrammed in the receiver module at delivery of the car. If uncertain about the key code programming reprogram the key codes. If the correct key code is programmed, continue fault tracing at F11.


- Switch off ignition.
- To reprogram the receiver module refer to Power Door Lock Control Module. Service and Repair
- Test all the transmitters by pressing the "LOCK" and "UNLOCK" keys.
Confirm central locking system activation.

If the central locking modules activate:
The receiver module has temporarily failed to accept key codes because of possible interference.
- If the fault is repeated install a new receiver module and program in the transmitter's key codes.

If the central locking modules do not activate:
- Continue to F11. F11 Checking Receiver Module Signal Pulse