License Plate Lamp: Service and Repair

License Plate Light, Bulb and Lamp Glass.

Replacing bulb and lamp glass







- Remove the two screws holding the tamp glass (TORX 10 or crosshead screws).

- Remove lamp glass carefully with a flat-bladed screwdriver.

- Pull blown bulb straight out.

- Replace bulb.

- Test

- Replace lamp glass if it shows signs of cracking

NOTE: RH and LH lamp glasses in 5-door models have different part numbers.
Cut off guide pin in earlier models which do not have a hole for this.

- Do not tighten screws too hard as lamp glass is plastic.