Faulty Signal

Faulty signal

Replacing the component




The diagnostic trouble code (DTC) is stored after three collisions. The control module must then be replaced.

Other information
- To access / replace the control module, see Replacing the SRS module Service and Repair.

Continue - Verification

-------------------------------------------------

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Reinstall the components and connectors etc.
- Ignition on.
Read off diagnostic trouble codes (DTCs).





Has the diagnostic trouble code (DTC) disappeared?

Yes - FAULT FOUND

No - Fault-tracing information
No Fault Found

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Replacing the component

-------------------------------------------------