Faulty Signal.
Faulty signal.
Status check
Note! If diagnostic trouble code (DTC) CI-132 is stored start fault-tracing according to this diagnostic trouble code (DTC) because it will probably solve the fault.
- Start engine.
- Go into scrolling values.
Read off engine speed (RPM).
Is the engine speed (RPM) within its permitted range?
Yes - Faulty signal. Intermittent fault
No - Checking cables and terminals
-------------------------------------------------
Fault-tracing information
Continued fault-tracing depends on the car ignition/engine control module (ECM).
Continue - Verification
-------------------------------------------------
Checking cables and terminals
Check combined instrument panel connector A, connector 24/13C and engine control module (ECM) connector for loose connections according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check cable between combined instrument panel #A11 and engine control module (ECM) #B21 for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults , an intermittent short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults and an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Was a fault detected in cables and terminals?
Yes - Verification
No - Checking for interference
-------------------------------------------------
Checking for interference
Check that the signal cable is not too close to sources of interference such as electric motors, ignition cables and car-phone cables.
Continue - Verification
-------------------------------------------------
Verification
Hint: After carrying out the repair check that the fault has been remedied.
- Ignition off.
- Reinstall connectors, components etc.
- Start engine.
- Go into scrolling values.
Read off engine speed (RPM).
Is the engine speed (RPM) within its permitted range?
Yes - FAULT FOUND
No - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit fault-tracing
No - Attempt New Test
-------------------------------------------------
Faulty signal. Intermittent fault
Faulty signal. Intermittent fault
Checking cables and terminals
Check combined instrument panel connector A, connector 24/13C and engine control module (ECM) connector for loose connections according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check cable between combined instrument panel #A11 and engine control module (ECM) #B21 for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults , intermittent short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults and an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Continue - Fault-tracing information
DONE
------------------------
Fault-tracing information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - FAULT FOUND
------------------------
-------------------------------------------------
-------------------------------------------------