Not Carried Out/Faulty

Not done/faulty

Checking equipment and software




To correctly carry out programming the ignition must be ON, the programming equipment must be connected and the correct software loaded for programming.
Check that ignition is ON.
Check ECC control module power supply to #B5 and to ground terminal #A23 for an open-circuit according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Check that programming equipment is correctly connected.
Check that the new software that is to be loaded is the correct version/revision.
Remedy as necessary.
Erase diagnostic trouble codes (DTCs) before starting programming.














Continue - Programming control module

-------------------------------------------------

Programming control module




- Ignition on.
- Connect the programming equipment.
After programming is completed, check that the ECC control module and climate control system are operating normally.

Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking equipment and software

FAULT FOUND - DONE

-------------------------------------------------