Internal Fault

Internal fault

IMM-112 Control module

Checking keys
Try to start the car with all the keys that the customer has.





Does the car start with all the keys the customer has?

Yes - Fault-tracing information

No - Programming keys

-------------------------------------------------

Fault-tracing information
The fault depends on the temporary disruption of the internal control module communication.

Continue - FAULT FOUND

-------------------------------------------------

Programming keys
- Erase diagnostic trouble codes (DTCs)?
- Program the key or keys which cannot be used to start the car according to Add a key Add A Key.
Try to start the car with the programmed key/s





Does the car start?

Yes - Fault-tracing information

No - Reading off diagnostic trouble codes (DTCs)

-------------------------------------------------

Fault-tracing information
The fault is caused by faulty data in the control module memory.

Continue - FAULT FOUND

-------------------------------------------------

Reading off diagnostic trouble codes (DTCs)




- Turn ignition off and on again.
Read diagnostic trouble codes (DTCs).





Has diagnostic trouble code (DTC) IMM-112 been stored again?

Yes - Replacing component

No - FAULT-TRACING FAILED

-------------------------------------------------

Replacing component
Try a new control module according to Replacing the control module Replacing the Control Module and initiate according to Initiating a new immobilizer control module Initiating A New Immobilizer Control Module.

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After finishing the repair check that the repair is successful and that the fault is corrected as follows.




- Ignition on.
Erase DTCs ?





Continue

------------------------

Verification, continued
- Switch off ignition for more than three seconds.
- Start car.
Read diagnostic trouble codes (DTCs).





Has the diagnostic trouble code (DTC) recurred?

Yes - VERIFICATION FAILED

No - VERIFIED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test


-------------------------------------------------