Not Programmed

Not programmed

IMM-132 Key codes

Checking initiation
Check if immobilizer is initiated by reading parameter IMMO PROG in MONITOR TEST.





Is the parameter NORM displayed?

Yes - Programming keys

No - Initiation

-------------------------------------------------

Initiation
Initiate the immobilizer control module according to Initiating a new immobilizer control module Initiating A New Immobilizer Control Module.

Continue - Reading off diagnostic trouble codes (DTCs)

-------------------------------------------------

Programming keys
- Program the car keys according to Add a key Add A Key.
Erase diagnostic trouble code (DTC) IMM-132.





Continue - Reading off diagnostic trouble codes (DTCs)

-------------------------------------------------

Reading off diagnostic trouble codes (DTCs)
- Ignition off.
- Ignition on.
Read diagnostic trouble codes (DTCs).





Has diagnostic trouble code (DTC) IMM-132 been stored again?

Yes - Replacing component

No - Fault-tracing information

-------------------------------------------------

Replacing component
Try a new control module according to Replacing the control module Replacing the Control Module and initiate the immobilizer control module according to Initiating a new immobilizer control module Initiating A New Immobilizer Control Module.

Continue - Verification

-------------------------------------------------

Fault-tracing information
The keys are programmed into the immobilizer control module memory.

Continue - Verification

-------------------------------------------------

Verification




Verification





Hint: After finishing the repair check that the repair is successful and that the fault is corrected as follows.

Does the car start with all keys ?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test


-------------------------------------------------