Incorrect Min Code
Wrong MIN code
Checking start
- Try to start the engine.
Does the engine start?
Yes - Fault-tracing information
No - Checking fault cause
-------------------------------------------------
Fault-tracing information
The cause of the fault is a temporary interruption of communication or that a engine control module (ECM) which is not aligned to the immobilizer control module it is programmed for, is mounted in the car.
Continue - Verification
-------------------------------------------------
Checking fault cause
Check which fault source corresponds with the circumstances.
1. A new immobilizer control module has been installed in the car.
2. A engine control module (ECM) not intended for the engine in the car has been installed.
Select one of the following options to continue.
1 - Initiating a new immobilizer control module
2 - Wrong type of engine control module (ECM).
-------------------------------------------------
Initiating a new immobilizer control module
The wrong engine choice was made when initiating the control module. Try a new control module according to Replacing the control module Replacing the Control Module and initiate according to Initiating a new immobilizer control module Initiating A New Immobilizer Control Module , be precise when entering the engine type.
Continue - Verification
-------------------------------------------------
Wrong type of engine control module (ECM).
Hint: If the problem occurred when another engine control module (ECM) was installed the immobilizer does not recognize the MIN code. The engine control module (ECM) from another engine type cannot be used for repairs for technical reasons.
Check carefully that the engine control module (ECM) is the correct one for the engine type
Continue - Verification
-------------------------------------------------
Verification
Verification
Hint: After finishing the repair check that the repair is successful and that the fault is corrected as follows.
- Ignition on.
- Erase diagnostic trouble codes (DTCs).
Try to start the car.
Does the car start?
Yes - VERIFIED
No - Verification, continued
------------------------
Verification, continued
Read diagnostic trouble codes (DTCs).
Has the diagnostic trouble code (DTC) been stored again?
Yes - VERIFICATION FAILED
No - VERIFIED
------------------------
VERIFIED - FAULT FOUND
VERIFICATION FAILED - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit fault-tracing
No - Attempt New Test
-------------------------------------------------