Internal Fault

Internal fault

Replacing the component
- The control module must be replaced if there is an internal fault. Replace the control module according to Replacing the Roll-over Protection System (ROPS) module Service and Repair.





Select Continue when the fault has been remedied.

Continue - Verification

-------------------------------------------------

Verification




Verification








- Ignition off.
- Reinstall the components, reconnect the connectors etc.
- Ignition on.
- Leave the ignition on for at least 10 seconds.
Read off diagnostic trouble codes (DTCs).





Does the diagnostic trouble code (DTC) recur?

Yes - VERIFICATION FAILED

No - VERIFIED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Replacing the component

-------------------------------------------------