Fault Counter

Fault counter

Replacing the component
The solenoids have a fault counter which counts each time a solenoid is activated. Diagnostic trouble code (DTC) ROP-451 is stored when the number of deployments reaches the decimal figure of 200.
The deployment counter can only be reset to zero when replacing the roll-over bar cassette.





Other information:
- To replace the rollover bar cassette, see Replacing the roll-over bar cassette Removal and Replacement.

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
Reset the deployment counter.





Can the deployment counter be reset?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Replacing the component

-------------------------------------------------