Internal Fault

Internal fault

Replacing the component
- The control module must be replaced if there is an internal fault. Replace the control module according to Replacing the SRS module Service and Repair.





Select Continue when the fault has been remedied.

Continue - Verification

-------------------------------------------------

Verification




Verification








- Ignition off.
- Reinstall the components, reconnect the connectors etc.
- Ignition on.
- Leave the ignition on for at least 10 seconds.
Read off diagnostic trouble codes (DTCs).





Does the diagnostic trouble code (DTC) recur?

Yes - VERIFICATION FAILED

No - VERIFIED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Replacing the component

-------------------------------------------------