Signal Faulty. Intermittent Fault

Faulty signal. Intermittent fault

Checking the connector and cable












- Ignition off.
- Disconnect combined instrument panel connector B.
- Disconnect the control module.
Check the control module connector and combined instrument panel connector B for contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Connect an ohmmeter between combined instrument panel 3 and control module 30. Check for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Connect an ohmmeter between control module 30 and ground. Check for an intermittent short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.













Other information:
- To disconnect / replace the combined instrument panel, see Combined instrument panel, Removal, replacement Combined Instrument Panel, Removal, Replacement.
- To disconnect / replace the control module, see Replacing the SRS module Service and Repair.

Select Continue when the fault has been remedied.

Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

FAULT-TRACING FAILED - DONE

Attempt New Test - Checking the connector and cable

-------------------------------------------------