Signal Missing. Intermittent Fault

Signal missing. Intermittent fault

Checking components and wiring












- Make a note of the anti-theft radio code.
- Ignition off.
- Disconnect the battery negative lead.
- Disconnect the connector from the seat belt tensioner.

Warning! Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected non-deployed pyrotechnical seat belt tensioner. This could deploy the seat belt tensioner!

- Disconnect the control module.
- Check the control module connector for contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check for damage carefully.
Connect an ohmmeter between seat belt tensioner 1 and 2. Test for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.

Other information:
- To access / replace the control module, see Replacing the SRS module Service and Repair.
- To access the seat belt tensioner, see Replacing front seat belts Front Seat Belt.









Select Continue when the fault has been remedied.

Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

FAULT-TRACING FAILED - DONE

Attempt New Test - Checking components and wiring

-------------------------------------------------