Front Seat With Prefitted SIPS Bag, Replacing

Front seat with prefitted SIPS bag, replacing

Preparations

Warning! The SIPS bag must not be repaired. Deformed front seats are replaced complete with a prefitted SIPS bag




If the SIPS bag has not detonated
First secure the SIPS bag
- Fold up the seat compartment. Lift up the front edge and press the compartment backward.
- Remove the transport lock from the holder on the inside of the seat compartment.
- Install the transport lock on the sensor unit.

Removing




Preparations:
- Ignition off.
- Disconnect the battery negative lead.




Remove:
- Seat compartment (A). Lift up the front edge and push backward.
- Seat belt from the seat mounting (bolt outside seat).
- Panel (B) over front edge runner
- 4 securing bolts (C) on runners
- Disconnect the connector to the heater element (under the seat cushion)
- Disconnect the connector to the seat belt lock (under the seat cushion)
Lift the seat straight up (guide pins at the front and rear).

Installation




First check that the new front seat's SIPS bag is secured with the transport lock fitted on the sensor unit.
- Assemble the seat in the reverse order to Removing.

Note! The outer, rear fastening bolt (C) is tightened last. Otherwise the seat will be secured askew.

Tighten to:
Seats/floor: 40 Nm
Belt: 20 Nm





When the front seat is in position
Do not forget to unlock the SIPS bag!
- Remove the transport lock on the sensor unit.
- Fit the transport lock from the holder on the inside of the seat compartment.
- Install the seat compartment.




- Change to the decal with the new date for the SIPS bag left and/or right side. Placed on the driver's side B-pillar
The decal is supplied with the new SIPS bag seat.