Check the Connection To the Control Module

Check the connection to the control module

Check the connection to the control module




- Ignition off
Check that the control module connector is connected correctly to the control module and that the connector's bottoming is working
Check that the control module connector, plug and socket are not damaged





Is the control module connected correctly ?

Yes - Verification

No - Take appropriate action for the control module connection

-------------------------------------------------

Take appropriate action for the control module connection
Connect the control module

Continue - Verification

-------------------------------------------------

Verification

Hint: After repair it is necessary to check that the fault has been rectified




- Ignition off
- Reconnect the connections, components etc.
- Ignition on
When the ignition is switched on, the ABS warning light is activated by the control module Check that the warning light goes out after approx.2 seconds

Note! The warning light will not go out if a fault is registered in the control module





Does the warning light go out shortly after being activated ?

Yes - Fault has been rectified

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

The fault should be diagnosed and remedied. Since this is not the case the fault-tracing process has failed.
Complete the fault-tracing for those fault or try again.

Do you want to terminate fault-tracing at this time?

Yes - Exit fault-tracing

No - Attempt New Test


-------------------------------------------------