Checking Diagnostic Trouble Codes (DTCs). ABS
Preparations
Before erasing diagnostic trouble codes (DTCs) all indicated faults must be corrected.
Note! To obtain the correct communication with the control module during the procedure the instructions concerning the ignition switch position must be followed.
Select 1 to continue erasing.
Select 2 to interrupt erasing.
1 - Erasing diagnostic trouble codes (DTCs)
2 - Exit procedure
-------------------------------------------------
Checking diagnostic trouble codes (DTCs). ABS
VST
Connection
Connection of Volvo Scan Tool (ST)
Volvo ST must be connected to VIDA PC and vehicle to DLC in passenger compartment.
Is Volvo ST connected and switched ON?
Yes - Erasing diagnostic trouble codes (DTCs)
No - Connection of Volvo Scan Tool (ST)
-------------------------------------------------
Connection of Volvo Scan Tool (ST)
Connection of Volvo ST
- Ignition off.
- Insert blue memory cassette into Volvo ST.
- Connect adapter 951 1457 Adaptor 951 1457 Adaptor to cable 951 1458 Scan tool cable 6 meters 951 1458 Scan Tool Cable 6 Meters.
- Connect VIDA communication lead between the adapter and the VIDA PC.
Continue - Connection to DLC
------------------------
Connection to DLC
- Connect Volvo ST cable (p/n) 951 1458 Scan tool cable 6 meters 951 1458 Scan Tool Cable 6 Meters to the DLC in passenger compartment.
- Switch on Volvo ST.
Continue - Erasing diagnostic trouble codes (DTCs)
-------------------------------------------------
Erasing diagnostic trouble codes (DTCs)
- Ignition on.
- Select the Volvo Scan Tool (ST) symbol to erase diagnostic trouble codes (DTCs).
0 - Test driving
-------------------------------------------------
Test driving
Note! If diagnostic trouble code (DTC)s have been erased, the ABS warning lamp will not go out until the car's speed is over 40 km/h, provided that no new diagnostic trouble code (DTC)s have been stored.
- Test drive the car at 50 km/h at least. The ABS warning lamp should go out.
Continue - Reading off diagnostic trouble codes (DTCs)
-------------------------------------------------
Reading off diagnostic trouble codes (DTCs)
- Ignition on.
- Select the Volvo Scan Tool (ST) symbol to read off diagnostic trouble codes (DTCs).
- Note stored diagnostic trouble codes (DTCs).
No diagnostic trouble codes (DTCs) should be stored.
OK - Information
Not OK - Fault-tracing information
-------------------------------------------------
Information
- Diagnostic trouble codes (DTCs) have been correctly erased and not restored.
-------------------------------------------------
Fault-tracing information
Diagnostic trouble codes (DTCs) not stored earlier
Diagnostic trouble codes (DTCs) have probably been stored during repair work.
Check that all connectors and components have been correctly connected.
Diagnostic trouble codes (DTCs) stored earlier
Diagnostic trouble codes (DTCs) have probably been stored during incorrectly performed repair work
Check that fault-tracing has been carried out correctly according to the relevant fault-tracing instructions.
It is possible to interrupt or make a new attempt to erase diagnostic trouble codes (DTCs).
Do you want to repeat attempt?
Yes - Repeat test
No - Exit test
-------------------------------------------------