O2 sensors - New routing of wiring
Bulletin:2250010
Group:
25
Date:
02/01/2000
New routing of wiring for 02 sensors
Models:
850, S70/V70/C70
1997-1998
Reference: This Service Bulletin laces the previous Service Bulletin 2-25-0010 from June 1999, which should be discarded.
Vehicles involved: B52X4X
Background:
To prevent contamination from reaching the probe's reference air, new routing has been developed for sensor wiring.
If one oxygen sensor is replaced, the new adapter wiring must be installed for both sensors.
Replacing the front heated oxygen sensor (HO2S)
Materials
Replacing the rear heated oxygen sensor (HO2S) B52X4S MY 97-98, B5234T MY 97
Materials
Replacing the rear heated oxygen sensor (HO2S) B5254T MY 97-98, B5234T MY 98
Materials
MOUNTING HEATED 02 SENSOR
Heated 02 sensor, mounting
Preparation
Turbocharged engines
Remove:
- Fresh air intake hose between air cleaner (ACL) housing and turbocharger (TC).
Naturally aspirated engines
Remove:
- the preheating hose.
Removing/installing heated 02 sensor
Remove the front heated O2sensor. Use tool no. 9995543
Install a new heated 02 sensor.
Note! AWD. Replace front 02 sensor from the engine compartment.
Installing adapter wiring
Note! The illustrations only illustrate one of the adapter wiring systems, but the same method applies to both front and rear 02 sensor.
When replacing the heated O2sensor adapter wiring (A), which is included in the kit, should be installed between the existing cable harness and the heated 02 sensor.
Form the adapter wiring (A) into a loop. Install a tie strap as illustrated.
Note! Ensure that the ends (B) of the adapter wiring protective sheath point downwards so that moisture does not gather in the protective sheath.
This illustration displays a late version of the heated 02 sensor cable bracket. (Early type bracket is shown in the next step.)
On AWD cars the cable for the front heated 02 sensor should be routed over the fresh air intake hose.
Note! Ensure that the ends of the adapter wiring protective sheath point downwards so that moisture does not gather in the protective sheath.
This illustration displays an early version of the heated 02 sensor cable bracket.
Installing fresh air intake hose:
Turbocharged engines
Install fresh air intake hose.
Naturally aspirated engines
Install preheating hose.
Erase diagnostic trouble code (DTC).
Test drive and check that no new diagnostic trouble codes (DTCs) have been stored.
WARRANTY STATEMENT: Claims may be submitted under the New Car Warranty when there is a documented customer complaint, using claim type 01.