Engine Speed Sensor: Service and Repair

1. Remove:
- Battery
- Air Cleaner housing (ACL) complete with intake pipe.
- Battery shelf Detach:
- ACL bracket.





2. Separation of transmission connector halves
- Remember rubber gasket.
- Detach connector from transmission.
- Remove cable clamps around cable harness and rubber grommet.
- Remove sockets from connector casing.
- Insert screwdriver between casing and socket and press catch in.
Press sockets from casing.





3. Remove socket for rpm sensor cables.
- 2-pin, pins 16 and 17.





4. Removal of sensor
- Clean thoroughly around sensor
- Remove sensor
- Install new sensor
- Rub some Vaseline on sensor O-ring.
- Tighten to: 5.5 Nm.





5. Reconnect connector halves.
- Ensure that rubber seal is in position.
- Install cable clamps round cable harness and rubber seal.
- Reinstall connector on transmission.
- Plug in connector from car Remember rubber seal.





6. Reinstall:
- ACL bracket.
- Battery shelf
- ACL housing with intake pipe and connections
- Battery
7. Checking DTCs
- Using a suitable scan tool, check that DTCs have been cleared.