Reading Input and Output Signals

The values and status of transmission control module input and output signals can be read using this function.

The following parameters can be read out:

- Engine speed.
- Engine coolant temperature.
- Engine coolant temperature sensor, voltage.
- Front heated oxygen sensor, voltage.
- Front heated oxygen sensor, preheating.
- Rear heated oxygen sensor, voltage.
- Rear heated oxygen sensor, preheating.
- Rear heated oxygen sensor, compensation.
- Fuel trim, status.
- Short-term fuel trim.
- Fuel trim, part load.
- Fuel trim, idling.
- Injection period.
- Mass air flow sensor, voltage.
- Load TI.
- Mass air flow sensor, air flow.
- Throttle angle.
- Throttle position sensor, voltage.
- Throttle, status.
- Idle air control valve, air flow.
- Idle air trim.
- Ignition advance.
- Ignition timing retardation requested by transmission control module, status.
- knock 1, status.
- knock 2, status.
- Fuel enrichment, status.
- Battery voltage.
- Vehicle speed.
- Air conditioning relay, status.
- Air conditioning pressure.
- Air conditioning pressure sensor, voltage.
- Engine cooling fan (FC), status.
- Operating cycle, status.
- Trip, status.
- Warm-up cycle, status.
- Fault active, status.
- Malfunction indicator lamp lit, status.
- Lighting of malfunction indicator lamp requested by transmission control module, status.
- Gear selector position, status.
- Canister purge valve.
- Fuel pump relay, status.
- Fuel shut-off system, status.
- Accelerometer*
- Accelerometer, voltage*
- Pulsed secondary air injection system pump, status.
- Flywheel adaption B.
- Flywheel adaption C.

*) Only certain markets, USA and Canada.