Transmission Temperature Sensor/Switch: Service and Repair

Fluid Temperature Sensor, Replacement
- Disconnect battery ground lead





- Unclip HO2S lead from transmission member and oil pan and open HO2S connectors.
- Remove front exhaust pipe.
- Disconnect sensor connector and wiring Move sensor wiring to right-hand side.





- Unscrew sensor from front oil pipe.

Installation
- Sensor is replaced complete with wiring and connector.
- Lubricate sensor 0-ring with ATF fluid.
- Install sensor and tighten to 10 Nm (7.5 ft lb).
- Install connector.
- Move wiring to left-hand side of transmission. Connect sensor connector and clip wiring in position.
- Install exhaust gas pipe and HO2S lead and connect HO2S connectors
- Reconnect battery ground leads and erase DTCs (if any).