Convertible Top Deck Lid Latch Actuator: Service and Repair

Before starting work, see CHA. Preparations Before Work. Procedures

CHE9 Removal:





- Move the hood to the position shown in the image.
- Ignition off.
- Make a note of any radio code.
- Disconnect the battery negative lead.





- Remove 12 screws from motor bracket.
- Pull out motor bracket.





- Remove 3 nuts from motor.

NOTE:
- Hold motor up with tool to avoid splitting rubber motor supports.
- Make sure drive wires do not move while replacing motor.

Remove motor.

CHE10 Installation:





If drive wires have moved during replacement, adjust so that A = 45 mm (1.8") from edge.

NOTE:
- Measurements should be the same at both sides and lock should be open.
- Make sure that flanges on wire engage in groove in motor.

Install in reverse order.