Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking the wires
Check relay coil driver for an intermittent short circuit to voltage supply by checking the voltage on 2 in the relay socket to relay 2/59.
For additional information regarding a short circuit to voltage supply, see Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Hint: The voltage between 2 and ground must be approximately 0 V.








If the voltmeter indicates an incorrect value, the control unit should be replaced.

Additional information:
- To access/replace the relay/fuse box in the boot, see Integrated relay/fusebox cargo compartment/Rear electronic module (REM), replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing.

Continue - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Exit fault-tracing

------------------------

Attempt New Test - Checking the wires

-------------------------------------------------