Checking The Clutch

Check the clutch

Check the clutch
Remove the V belt
Disconnect the compressor connector. Connect battery voltage directly to the clutch and check if the clutch operates.
(Ensure that ground / the ground terminal is OK)
Measure the resistance in the clutch:









The ohmmeter should read approximately 2-5 ohms.

OK - No Fault Found

Not OK - Replacing the component

-------------------------------------------------

Replacing the component
Replace the clutch, seeor check the connector according to Checking wiring and terminals. Permanent fault Checking Wiring And Terminals. Permanent Fault.

Continue - FAULT FOUND

-------------------------------------------------