Procedures

Special Tools
999 5702

Removing spark plugs





- Remove both engine covers.
- Disconnect the connectors.
- Disconnect the HT lead.
- Remove the mounting screws.
- Pull off the ignition coils.
- Remove the spark plug with special tool 999 5702.

Installing spark plugs:





- Check the rubber and the spring inside. Replace if necessary.
- Check the spark gap: 0.7 - 0.8 mm.
- Install the spark plugs. Screw the spark plugs in until the gasket is pressed against the cylinder head. Tightening torque 25 Nm. Use special tool 999 5702.
- Position the ignition coils. Press the ignition coils into place.
- Tighten the screw. Tightening torque 10 Nm.
- Connect the high tension cables.
- Reconnect the connectors.

Note! The gray connector is for the left coil (cylinders 2 and 3), the blue connector is for the right coil (cylinders 1 and 4).

- Check the function.
- Install both engine covers.