Connecting the Breakout Box, CCM

CONNECTING THE BREAKOUT BOX

Special tools: 9511463 , 981 3190 , 9511508

General information
Check that the male and female terminals on the connectors are undamaged and secure (cannot be pressed in). Check that the cables to the female terminals are secured to the terminal pins. The breakout box is designed to facilitate reading oft the control module input and output signals when the control module is connected, and the cable and component resistance when the control module is disconnected. The use of a breakout box reduces the risk of accidental short-circuited cables and damage to the connector pins.

Connecting the breakout box
- Ignition off
- To expose the climate control module (CCM) connector, Service and Repair
- To expose the evaporator temperature sensor connector, Service and Repair
- To expose the sun sensor connector, Service and Repair
Connect breakout box 981 3190 to the adapter.

Climate control module (CCM)
- Connect adapter 9611463 to control module connectors A and B
- For connector A, terminals #A1~A16 correspond to terminals #25440 on the breakout box
- For connector B, terminals #B14B22 correspond to terminals #1~22 on the breakout box.

Evaporator temperature sensor
- Connect adapter 9511508 to the evaporator temperature sensor connector
- Terminals #145 on the connector correspond to terminals #26430 on the breakout box.

Sun sensor
- Connect adapter 9511508 to the sun sensor connector
- Terminals #145 on the connector correspond to terminals #26430 on the breakout box.