Signal Too Low. Permanent Fault

Signal too low. Permanent fault

Checking the components and wiring
Check the canister valve's resistance.
Check the signal line between control module #B40 (#B50) and the canister valve, connection 2, for short-circuiting to ground according to: Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault
Remedy as necessary.

Other information
- Connecting the breakout box, B5254T2 Connecting the Test Box
- To access/replace the canister valve, see: Replacing the shut-off valve for the carbon filter container Service and Repair
- Component specifications Specifications
- For information about signals 5-cylinder engine, see: Signal specification Signal Specification
- For information about signals 6-cylinder engine, see: Signal specification Signal Specification









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reconnect connectors, reinstall components.
- Ignition on.
- Activate EVAP canister shut-off valve.
A "click" should be heard when the EVAP canister shut-off valve is activated.









Is the EVAP canister shut-off valve working?

Yes - Verification completed

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the components and wiring

-------------------------------------------------