Operation CHARM: Car repair manuals for everyone.

Checking the Door Warning Lamp






Checking the door warning lamp

Checking the wires and components
Check that the bulb socket and lamp are intact.
Check the wire between control unit #7A and door warning lamp #1 for an open circuit, as described in Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Check the wire between door warning lamp #2 and the ground point for an open circuit, as described in Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Do the necessary corrective action.

Additional information:
- For information on signals and additional values, see Signal specification Signal Specification, Driver Door Module (DDM) / Passenger Door Module (PDM).
- To connect the test box, see Connecting the breakout box Connecting the Breakout Box.
- To access/replace door warning lamp, see Bulb, warning lamp, side door, replacing Service and Repair.









Continue - FAULT FOUND

-------------------------------------------------