Description Of Programmed Data

Description of programmed data

General
Both the new control modules for the central electronic module (CEM) and the control modules supplied as replacement parts are preprogrammed with the values from the factory. These preprogrammed values may differ depending on the version of the central electronic module (CEM).
Programming must be carried out when replacing the central electronic module (CEM), after market installation of front fog lamps, or when the customer wishes to modify the function of the tailgate wiper or approach lights.

Note! If an internal error occurs in the control module, it will control the output signals according to preprogrammed values.

Automatic low beam
This parameter determines whether low beam will be on when the ignition is switched on and when the lighting switch is in position 0 and also within which range the instrument lighting can be adjusted using the control. The available range for the instrument lighting is fixed in percentage for each setting.

Note! This function is market dependent. Contact the dealer if uncertain about this function. Unless otherwise stated, automatic low beam is standard for the USA.

The following alternatives are available:
- On 20-100%
- Off 20-100%
- On 6-100%
- Off 6-100%
- USA on 6-100%
- USA off 6-100%
- Canada on 6-100%.

Note! In Europe a new central electronic module was introduced in week 13 2003. The part number is 3063 8707 and 3063 8708. These control modules must be programmed with a range of 6-100% instead of 20-100%. Older control modules are still programmed with a range of 20-100%.The newer control module cannot be programmed with settings of a range of 20-100%. The older control module cannot be programmed with a range of 6-100%.

Twin headlamps
This parameter indicates if the car is equipped with twin headlamps (separate headlamp inserts for high and low beam) or not.

Note! If the car is equipped with separate headlamp inserts for high and low beam, low beam will be lit when high beam or high beam flash is activated.

The following alternatives are available:
- Yes
- No.

Front fog lamps
This parameter indicates whether the car is equipped with front fog lamps or not.

Note! The parameter must be programmed when installing after market fog lamps.

The following alternatives are available:
- Yes
- No.

Tailgate wiper
This parameter indicates whether the car is equipped with a tailgate wiper or not.

The following alternatives are available:
- Yes
- No.

Tailgate wiper when reversing
This parameter indicates whether the tailgate wiper starts when back-up (reverse) gear is selected or not.

Note! The tailgate wiper only starts if the windshield wipers are activated.

The following alternatives are available:
- Yes
- No.

Approach lights
This parameter indicates how long the approach lights should remain lit.

Note! The parameter can only be read. It cannot be programmed.

The following alternatives are available:
- 30 secs.