Description of Programmed Data

Description of programmed data

General
Both the new control modules for the central electronic module (CEM) and the control modules supplied as replacement parts are preprogrammed with the values from the factory. These preprogrammed values may differ depending on the version of the central electronic module. Programming must be carried out when the central electronic module (CEM) is replaced, when after market front fog lamps are installed, or when the customer wishes to modify the functions of the tailgate wiper or approach lights.

NOTE: If an internal error occurs in the control module, it will control the output signals according to preprogrammed values.

Automatic low beam
This parameter determines whether low beam should be on when the ignition is switched on and the lighting switch is in position 0. This function is market dependent. Contact the dealer if you are not sure about this function. Unless otherwise stated, automatic low beam is standard for the USA.

The following alternatives are available:
- on
- Off
- USA, on
- USA, off
- Canada, on.

Twin headlamps
This parameter indicates if the car is equipped with twin headlamps (separate headlamp inserts for high and low beam) or not.

NOTE: If the car is equipped with separate headlamp inserts for high and low beam, low beam will be lit when high beam or high beam flash is activated.

The following alternatives are available:
- Yes
- No.

Front fog lamps
This parameter indicates whether the car is equipped with front fog lamps or not.

NOTE: The parameter must be programmed when installing after market fog lamps.

The following alternatives are available:
- Yes
- No.

Tailgate wiper
This parameter indicates whether the car is equipped with a tailgate wiper or not.

The following alternatives are available:
- Yes
- No.

Tailgate wiper when reversing
This parameter indicates whether the tailgate wiper starts when back-up (reverse) gear is selected or not

NOTE: The tailgate wiper only starts if the windshield wipers are activated.

The following alternatives are available:
- Yes
- No.

Approach lights
This parameter indicates how long the approach lights should remain lit.

NOTE: The parameter can only be read. It cannot be programmed.

The following alternatives are available:

- 30 Secs.