Programming A New Control Module

Programming a new control module

Ordering software
PIN codes must be programmed into the control module after a newEMS2000 engine control module (ECM) has been installed in the car. The PIN codes are retrieved from the Volvo central database.
The new control module must be installed in the car before this programming is carried out. The malfunction indicator lamp (MIL) will flash on a new control module until the programming is complete.

Note! A new control module which is installed and programmed in a car is adapted for that particular car only. The engine control module (ECM) must not be moved to another car.

Order software for S/V 40according to9139873.

Select Continue.

Continue - Programming engine control modules (ECMs)

-------------------------------------------------

Programming engine control modules (ECMs)

Caution! Programming can take place when the software is available.

Program the engine control module (ECM) for S/V 40according to9139873.

Select Continue.

Continue - DONE

-------------------------------------------------