Connecting the Breakout Box, ECM (EMS 2000)

Connecting The Breakout Box, ECM (EMS 2000)

Special tools: 951 1314, 981 3190


Connecting the breakout box to the connector at the engine control module (ECM)



- Ignition off
- Remove the security strap around the Engine Control Module (ECM). Remove the control module from the bracket
- Disconnect the Engine Control Module (ECM)
- To avoid interfering with the pedals, the cable harness with the control module connector must be pulled over to the right of the center console (left hand drive) or to the left of the center console (right-hand drive). The connector must be placed on the floor
- Check that the male and female terminals in the control module and the control module connector are intact and secure. Check that the wiring to the female terminals is properly secured to the pins
- In particular, check the terminal pins relevant to the Diagnostic Trouble Code (DTC) or symptom
- Connect adapter 951 1314 to the Engine Control Module (ECM) connector. Connect breakout box 981 3190 to the adapter.