Control Module, Climate

Control module, climate

Control module, replacing

Conditions




- Make a note of the radio code
- Switch off the ignition
- Disconnect the battery ground lead
- Remove the radio
- Disconnect the connectors
- Remove the storage compartment in the center console.

Removing the front panel




- 1: Press up the catches behind the holes in the front panel
- 2: At the same time pull the lower section of the panel towards you. (Use a weatherstrip tool.)
- 3: Press the whole panel upwards slightly. Pull it towards you from the top. (The controls remain on the heater control panel.).

Removing the control module




- Remove the 3 screws
- Disconnect the connectors
- Removing the control panel.




- Remove the 2 screws. Move the heater unit downwards at an angle
- Disconnect the green connector (GN)
- Remove the air hose
- Remove the heater unit.

Installing the control module




- Connect the green connector (GN)
- Connect the air hose
- Position the heater unit
- Install the 2 screws.




- Connect the connectors
- Install the dashboard
- Install the 3 screws.

Installing the front panel




- Install the front panel
- Install the storage compartment in the center console
- Connect the connectors and the antenna cable to the radio
- Install the radio.

Remaining operations
- Turn the ignition key to position II
- Connect the negative battery lead
- Enter the radio code
- Set the clock to the correct time.

Finishing
Self-adjust the damper motor limit positions according to VIDA vehicle communication.
For more information about the adjusting the damper motors, see Self adjustment of damper motor limit positions Self Adjustment Of Damper Motor Limit Positions.