Turbo Boost Sensor: Service and Repair

Boost pressure sensor 2, replacing

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the pressure sensor

Warning! Use protective goggles





Remove:
- the casing over the injection valves (2 screws)
- the connector from the boost pressure sensor.
Blow clean with compressed air around the boost pressure sensor.

Remove:
- the screw for the boost pressure sensor
- the boost pressure sensor.

Installation

Installing the pressure sensor

Install:
- a new boost pressure sensor
- the screw for the boost pressure sensor
- the connector for the boost pressure sensor
- the casing over the injection valves (2 screws).