Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information ECM-2000
Condition
This diagnostic trouble code (DTC) is stored if the engine control module (ECM) registers a short-circuit to ground or supply voltage or an open-circuit in the engine coolant temperature (ECT) sensor circuit.
The diagnostic trouble code (DTC) can be diagnosed when the ignition is switched on.
Substitute value
- When starting: The intake air temperature (IAT) is used if no fault has been detected on the intake temperature sensor Otherwise the constant +20 °C is used
- After starting: The engine coolant temperature (ECT) is calculated based on a model
- The cooling fan runs at low-speed.
Possible source
Signal too high
- Short-circuit to supply voltage in the signal cable
- Open-circuit in the signal cable
- Damaged engine coolant temperature (ECT) sensor.
Signal too low
- Short-circuit to ground in the signal cable
- Damaged engine coolant temperature (ECT) sensor.
Fault symptom[s]
- Malfunction indicator lamp (MIL) lit
- Engine difficult to start when warm
- Uneven idle
- The engine stops, but only when it is at operating temperature
- The engine cooling fan (FC) runs continuously even when the ignition is switched off.