Signal Too Low
Signal too low
Checking for intermittent faults
- Ignition on
- Activate the evaporative emission system (EVAP) valve.
A click should be heard when the evaporative emission system (EVAP) valve is activated.
Is the evaporative emission system (EVAP) valve working?
Yes - Fault-tracing information
No - Checking the wiring and component
-------------------------------------------------
Checking the wiring and component
Check the cable between control module terminal #A2 and evaporative emission system (EVAP) valve terminal 2. Check for a short-circuit to ground.
Remedy as necessary.
Other information
- Connecting the breakout box Connecting the Breakout Box
- Signal specification Signal Description / Specification
- Engine control module (ECM), replacing Service and Repair
- Location of components Locations
- Checking wiring and terminals Checking Wiring And Terminals
Was a fault found in the wiring?
Yes - Verification
No - Replacing the component
-------------------------------------------------
Replacing the component
- Ignition off.
Try a new canister purge (CP) valve.
Other information
- Location of components Locations
Continue - Verification
-------------------------------------------------
Fault-tracing information
The control module has previously registered a fault. The fault is now no longer present.
Continue - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - Fault Found
------------------------
Attempt New Test - Checking for intermittent faults
FAULT FOUND - DONE
DONE - DONE
-------------------------------------------------
Verification
Verification
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition off
- Reconnect the connectors, reinstall components etc.
- Ignition on
- Activate the evaporative emission system (EVAP) valve.
A click should be heard when the evaporative emission system (EVAP) valve is activated.
Is the evaporative emission system (EVAP) valve working?
Yes - VERIFIED
No - VERIFICATION FAILED
------------------------
VERIFICATION FAILED - Fault-tracing information
FAULT FOUND - Fault Found
FAULT-TRACING FAILED - No Fault Found
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - FAULT-TRACING FAILED
No - Attempt New Test
------------------------
FAULT-TRACING FAILED - FAULT-TRACING FAILED
Attempt New Test - Checking for intermittent faults
-------------------------------------------------